Friday, September 16, 2016

Hitting Irons In Golf: Guide For Novices

Let’s admit, all golfers love to hit a huge drive off the tee and over the treetops towards the hole. A long drive is always very impressive, specifically if you are having fun with new acquaintances; however, long drives are useless if you cannot sink a putt. Short shot with an iron is far more essential than long shots with a wood. For newbies or untrained golfers, short is one of the most difficult shot to complete in a play. This write-up will help you on how to hit irons efficiently.

Step #1: Correct Posture And Body Alignment

The first step to successful hits is correct setup concerning your posture and body alignment. Bending of the body is what many beginner in golf players usually do, which is wrong. Instead of the waist, an inexperienced golfer normally bend from the back. This will definitely affect the trajectory adversely and will cause a great muscle pain in the back. Sustain a straight back while golfing but not rigid. Tilt your body by the waist and also allow a swing through your hips. You need to keep your body in an even position on your feet to keep the balance of the body through the swing.

Step #2: Ball Placement

In setting up iron shot, ball positioning is the most ignored factor. Long drives is the most considered position by a lot of golfers but short shot is also crucial. The placement we are talking about here is regarding the position based on your body setup. The ball being not farther back on the sternum and not far enough beyond the left armpit is the proper ball and body placement. One mistake novices make is playing the shot too far forward resulting in poor slices and putts. If the ball heads into the ground when engaged, try straightening your sternum and hitting it again.

Step #3: The Takeaway Position

The takeaway position refers to the manner in which the club is pulled back and hit through. The takeaway position is very important to possess a great swing in a play and the success it will make. When hitting an iron, the strategy being followed is the 2-8-2 rule. The first 2 refers to first two inches of the takeaway where the club travels straight back. This requires the body (arm, legs and shoulders) to go as one . The “8” refers to the eight inches when in the club curves in an upward direction but with out moving the wrists. At twelfth inches, the wrist turns and place the shaft in a horizontal position to the ground. The hands must level to the shoulder height and the shoulder must be tight. Right after performing the takeaway position, follow along the target line and hit the ball by a square iron face.

Step #4: Take Consideration of the Course

Needless to say, while the set up and follow through of the swing are both extremely important, it is also vital to consider the layout. Any changes while performing a swing or even takeaway, would be due to the surface of the ground where it is being carried out. When the ball is to be performed on a downhill slope, it is best to complete a downswing at the point where the ball will fall towards the hole. For example, a slight downhill and green ground would be perfect for a slight curve to possess a gravitational pull. In addition, a good shot will be carried out when you get rid of any obstacles along the path.

The post Hitting Irons In Golf: Guide For Novices appeared first on Golf Gulf Florida.

http://ift.tt/2cKeCBT




from WordPress http://ift.tt/2cT50SM

No comments:

Post a Comment